Lost your key fob or need to program a new one for your 2005 Honda CRV? Don’t worry, you might be able to do it yourself! This guide provides step-by-step instructions based on user experience to help you program a new 2005 Honda Crv Key Fob without a trip to the dealership.
Step-by-Step Guide to Program Your 2005 Honda CRV Key Fob
Before you begin, please note that entering programming mode will erase all previously programmed remotes. You will need to reprogram all of your key fobs during this process. Ensure you have all remotes you intend to use ready before starting. It’s also crucial to complete each step within 5 seconds of the last to prevent the system from exiting programming mode.
Here’s how to program your 2005 Honda CRV key fob:
-
Turn the ignition switch to the ON (II) position. This is the position right before you would start the engine.
-
Press the LOCK or UNLOCK button on one of your key fobs. It doesn’t matter if the remote is currently programmed or not for this step.
-
Turn the ignition switch to the LOCK (0) position. This is the position where the car is completely off.
-
Repeat steps 1, 2, and 3 two more times using the same key fob from step 2. You will have cycled the ignition switch ON-LOCK a total of three times, pressing the key fob button each time while the ignition is ON.
-
Turn the ignition switch to the ON (II) position again.
-
Press the LOCK or UNLOCK button on the same key fob used in step 2. If you have successfully entered programming mode, the power door locks should cycle (lock and unlock) automatically. This confirms you are now in programming mode.
-
For each key fob you want to program, press the LOCK or UNLOCK button. After pressing a button on each remote, the door locks should cycle again to confirm that the system has accepted and programmed that particular remote.
-
Turn the ignition switch to the LOCK (0) position to exit programming mode.
-
Test all of your programmed key fobs to ensure they are working correctly.
A Note About the Immobilizer Chip
One thing to be aware of when replacing your 2005 Honda CRV key fob is the immobilizer chip. Some aftermarket key fobs might require you to transfer the immobilizer chip from your original key or a valet key to the new key fob for the car to start. This is a separate security feature from the remote locking/unlocking and is related to starting the engine. If you encounter issues starting your CRV after cutting and programming a new key fob, this could be the reason. In such cases, carefully switching the immobilizer chip might be necessary, a process that some users have found to be straightforward.
By following these steps, you should be able to program your 2005 Honda CRV key fob yourself and regain full remote access to your vehicle. Remember to always double-check your owner’s manual for any specific instructions related to your vehicle model. Good luck!
