Is your 2008 Acura Tl Key Fob malfunctioning or did you recently replace it? Reprogramming your key fob can often be done at home, saving you a trip to the dealership. This guide provides simple, step-by-step instructions to program your 2008 Acura TL key fob, ensuring you regain remote access to your vehicle quickly and efficiently.
Follow these steps carefully to program your 2008 Acura TL key fob:
-
Ensure all doors are closed, including the trunk lid and hood. This is crucial for the programming sequence to initiate correctly.
-
Turn the ignition switch to the ON position (II). This means turning the key to the point right before you would start the engine, illuminating the dashboard lights.
-
Within 1 to 4 seconds of turning the ignition ON, press either the lock or unlock button on your key fob. Make sure to aim the transmitter towards the keyless receiver unit. This unit is typically located behind the driver’s side dashboard.
-
Within 1 to 4 seconds after pressing the key fob button, turn the ignition switch to the OFF position.
-
Again, within 1 to 4 seconds of turning the ignition OFF, turn the ignition switch back to the ON position (II).
-
Repeat steps 3, 4, and 5 a total of four times. You will be cycling the ignition ON and OFF while pressing the key fob button each time the ignition is turned ON.
-
After the fourth cycle (ignition turned ON for the fourth time and key fob button pressed), turn the ignition switch OFF for the final time.
-
Turn the ignition switch ON (II) one last time.
-
Press the lock or unlock button on the key fob again, aiming at the receiver.
-
Listen for the sound of the door lock actuators. Within 1 to 4 seconds, you should hear the doors lock and unlock, confirming that the system has entered programming mode. Immediately press the lock or unlock button on the key fob once more to store the code. If you skip this second press, the programming will not be saved.
-
If you have additional key fobs to program (up to two more), you have 10 seconds to program them. Aim each additional transmitter at the keyless receiver and press the lock or unlock button. You should hear the door lock actuators respond after each successful programming.
-
Finally, turn the ignition switch to the OFF position and remove the key from the ignition.
-
Test each programmed key fob to confirm they are working correctly. Ensure the lock, unlock, and panic buttons are functioning as expected.
By following these steps, you should be able to successfully program your 2008 Acura TL key fob. If you encounter any issues, double-check each step and timing, or consult your Acura owner’s manual for further assistance.
