Is your 2008 Honda Pilot key fob malfunctioning or did you recently purchase a replacement remote? Don’t worry, programming your key fob is a straightforward process you can accomplish right at home. This guide will provide you with clear, easy-to-follow instructions to program your 2008 Honda Pilot key fob, saving you time and money compared to dealership programming.
Before you begin the programming sequence for your 2008 Honda Pilot key fob, ensure you have all the remotes you intend to program for your vehicle readily available. It’s crucial to program all remotes in a single programming session. Also, verify that all doors, including the rear hatch or trunk, are completely closed. You will only need one working remote to initiate the programming mode, but remember, all remotes must be programmed during this session. It’s important to note that each step in the programming process must be completed within 5 seconds to ensure successful programming.
Here’s how to program your 2008 Honda Pilot key fob:
- Get inside your 2008 Honda Pilot and ensure all doors and the trunk are securely closed.
- Insert your key into the ignition. Turn the ignition key to the “ON” position. This is the position marked as “II” on your ignition bezel, where the dashboard lights illuminate. Within 5 seconds of turning the key to “ON”, press the “Lock” button on your key fob remote for approximately one second, and then release it.
- Turn the ignition key to the “OFF” position. This position, marked as “I” on the ignition bezel, will turn off the dashboard lights.
- Repeat steps 2 and 3 three more times. You will be turning the key to the “ON” position a total of four times, pressing the lock button each time while in the “ON” position. Remember, each step must be completed within 5 seconds of the previous one.
- On the fourth turn of the key to the “ON” position, press the “Lock” button on one of your remotes. You should hear the door locks cycle, making a “clunk” sound. The locks will not actually lock or unlock at this point; this sound indicates that your 2008 Honda Pilot system has successfully entered programming mode. Do not turn the key off after this step.
- Within 5 seconds of entering programming mode, and within 5 seconds of each other, take each remote you wish to program and press the “Lock” button on each for about a second, then release. This entire step, programming all remotes, must be completed within 10 seconds. Each time you press a remote button, the door locks should cycle again, confirming that remote’s programming. You can program up to three remotes in total.
- Turn the ignition completely off and remove the key from the ignition. Exit your Honda Pilot and close the door.
Your 2008 Honda Pilot key fob should now be programmed and fully functional. Test the lock, unlock, and panic buttons to ensure proper operation. If your key fob has a trunk or hatch release button, you may need to hold it down for a few seconds for the trunk or hatch to open.
If you require a replacement key fob for your 2008 Honda Pilot, or for any other vehicle, visit us at Keylessentryremotefob.com. We offer a wide selection of key fobs and remotes. This programming procedure is designed for the FCC ID CWTWB1U545, which is a common part number for 2008 Honda Pilot key fobs.
