Lost your 2008 Pontiac G6 Key Fob or just want to program a new one without the hefty locksmith price tag? You’re in the right place. Many Pontiac G6 owners have successfully programmed their key fobs themselves, and you can too! This guide provides straightforward, step-by-step instructions to program your 2008 Pontiac G6 key fob, potentially saving you a significant amount of money compared to dealership or locksmith services.
This method is based on user-verified procedures and is designed to be done without any special tools. Whether you purchased a new key fob online or are working with a spare, follow these instructions carefully to program your remote transmitter to your 2008 Pontiac G6.
Step-by-Step Guide to Program Your 2008 Pontiac G6 Key Fob
Before you begin, ensure you have all key fobs you intend to use for your vehicle, as programming the first fob will erase all previously programmed fobs. You can program up to four transmitters using this method.
Step 1: Get Comfortable in the Driver’s Seat
While the original instructions mention the driver’s seat, some users find it easier to perform these steps from the front passenger seat. Choose whichever is more comfortable for you to access the ignition and fuse panel.
Step 2: Remove the Ignition Key and Close All Doors
Take the key completely out of the ignition. Make sure all doors of your 2008 Pontiac G6 are fully closed.
Step 3: Locate and Remove the MALL PGM Fuse
Find the fuse panel in your Pontiac G6. Consult your vehicle’s owner’s manual if you are unsure of its location. Identify the “MALL PGM” fuse and carefully remove it. This fuse is crucial for initiating the key fob programming sequence.
Step 4: Turn the Ignition to the ACC Position
Insert the ignition key and turn it to the “ACC” (Accessory) position. This is typically one click forward from the “OFF” position.
Step 5: Cycle the Ignition
Quickly turn the ignition from the “OFF” position to the “ACC” position and back to “OFF” again within one second. This rapid cycling is part of the programming initiation.
Step 6: Open and Close the Door
Open and then close any door on your Pontiac G6. This action signals the system to enter programming mode.
Step 7: Listen for the Chime
Pay close attention and listen for a chime. This chime indicates that the remote control door lock receiver has successfully entered the programming/diagnostic mode. If you do not hear a chime, you will need to repeat steps 1 through 6 carefully.
Step 8: Program the Transmitter
Take your key fob transmitter. Simultaneously press and hold both the “LOCK” and “UNLOCK” buttons for approximately 14 seconds. After about 7 seconds, you may hear a chime confirming synchronization, and after 14 seconds another chime will confirm successful programming.
Step 9: Program Additional Transmitters (If Necessary)
If you have additional key fobs to program, repeat Step 8 immediately for each additional transmitter.
Step 10: Final Steps
Remove the ignition key from the ignition lock cylinder. Reinstall the “MALL PGM” fuse back into its original location in the fuse panel.
Step 11: Test Your Key Fobs
Thoroughly test all programmed key fobs to ensure they are working correctly. Check the lock, unlock, and any other functions your key fob may have to confirm successful programming of your 2008 Pontiac G6 key fob.
Conclusion
Programming your 2008 Pontiac G6 key fob yourself is a feasible DIY project that can save you money and time. By following these steps, you can quickly and efficiently program your key fob without needing professional assistance. Enjoy the convenience of your programmed key fob and the satisfaction of a job well done!
