Lost or damaged your 2009 Nissan Murano key fob? Don’t worry, replacing it doesn’t have to be a trip to the dealership and a hefty bill. This guide provides a straightforward method to program a new key fob for your 2009 Nissan Murano, potentially saving you time and money. While some instructions might seem complicated, this method is known to be effective and user-friendly. Let’s get your remote working again!
Programming your 2009 Nissan Murano key fob can be done in a few simple steps right in your driveway. Before you begin, ensure all doors are closed and locked using the driver’s side power lock/unlock switch. This is crucial for initiating the programming sequence.
The next step involves using your key in the ignition. You’ll need to insert and remove your key from the ignition key cylinder multiple times within a 10-second window. The exact number of cycles can vary; in some cases, it might take around 12 insert/remove cycles. Successful completion of this step is indicated by the flashing of your Hazard Lamps. This flash signals that your Nissan Murano has entered programming mode and is ready to learn the new key fob.
Alt: Inserting and removing a Nissan car key into the ignition cylinder to program a key fob.
Important Note: Make sure to fully withdraw the key from the ignition cylinder each time. Performing this procedure too quickly might prevent the system from entering the programming mode. Patience and a steady rhythm are key here.
Once the hazard lamps have flashed, insert the key back into the ignition cylinder and turn it to the ACC (Accessory) position. Now, within 5 seconds of turning the key to ACC, take your new remote transmitter and push ANY button on it. If the programming is successful for this transmitter, your Hazard Lamps should flash again, confirming the signal has been received and recognized.
Alt: A Nissan Murano key fob remote control being programmed.
Important Note: It’s essential to press the button on the remote transmitter only ONCE during this step. Pressing the button multiple times can disrupt the programming procedure and cause it to fail.
If you have additional transmitters to program, including any existing remotes you want to continue using, you can program them now. To do this, unlock and then lock all doors again using the driver’s side power lock/unlock switch. Within 5 seconds of locking the doors, push ANY button on the next remote transmitter you want to program. Again, your Hazard Lamps should flash to confirm successful programming of each additional remote. Repeat this step for every transmitter you need to program.
After you have programmed all desired key fobs, turn the key to the OFF position and remove it from the ignition. Unlock the doors using the driver’s side power lock/unlock switch and open the driver’s side door to finalize the process. Test each of your programmed key fobs to ensure they are working correctly with your 2009 Nissan Murano. You should now be able to lock and unlock your doors remotely.
This method provides a practical solution for 2009 Nissan Murano Key Fob Replacement, potentially saving you the expense of professional programming. By following these steps carefully, you can regain the convenience of remote access to your vehicle quickly and efficiently.
