Lost your 2009 Pontiac G6 key fob or need to program a new one? Paying a locksmith or dealership for key fob programming can be costly. Fortunately, programming your Pontiac G6 key fob yourself is a straightforward process that can save you time and money. This guide provides easy-to-follow 2009 Pontiac G6 Key Fob Programming Instructions, allowing you to get back on the road quickly.
Step-by-Step Guide to Program Your 2009 Pontiac G6 Key Fob
This no-tool-required method will guide you through programming up to four key fobs for your 2009 Pontiac G6. It’s crucial to follow each step precisely to ensure successful programming.
Preparation Steps:
- Sit comfortably in the driver’s seat (the front passenger seat can also provide easy access).
- Remove the ignition key from the ignition lock cylinder.
- Ensure all vehicle doors are completely closed.
- Locate the MALL PGM fuse in your Pontiac G6’s fuse panel and remove it. (Refer to your vehicle’s owner manual for the exact location of the fuse panel and the MALL PGM fuse).
Programming Procedure:
-
Turn the ignition lock cylinder to the ACC (Accessory) position.
-
Immediately turn the ignition lock cylinder OFF, and then back to the ACC position again within one second.
-
Open and then close any vehicle door.
- You should hear a chime sound, indicating that the remote control door lock receiver has entered programming/diagnostic mode. If you do not hear a chime, repeat steps 1-7.
Transmitter Synchronization and Programming:
-
Press and hold both the LOCK and UNLOCK buttons on the key fob simultaneously for approximately 14 seconds.
- After about 7 seconds, you may hear a chime, confirming successful synchronization.
- After approximately 14 seconds, you will hear another chime, indicating successful programming of the key fob.
-
Repeat step 8 for each additional key fob you wish to program. Remember, you must program all key fobs (both old and new) at this time as the process erases previous programming. Up to 4 transmitters can be programmed.
-
Remove the ignition key from the ignition lock cylinder.
-
Re-install the MALL PGM fuse back into its location in the fuse panel.
Verification:
- Test each programmed key fob to ensure they operate the door locks and other keyless entry functions correctly. Refer to your owner’s manual for details on keyless entry system operation.
By following these 2009 Pontiac G6 key fob programming instructions, you can easily program your key fobs yourself, saving both time and money. Enjoy the convenience of your functioning remote!
