Lost your key fob or need to program a new one for your 2013 Dodge Durango? Fortunately, programming a new key fob for your 2013 Dodge Durango can often be done in the comfort of your own driveway, saving you a trip to the dealership. This guide provides straightforward instructions to program your key fob, assuming you already have one working remote.
Important Note: These instructions are specifically for adding an additional key fob to your 2013 Dodge Durango system when you already possess a working remote. If you do not currently have a working key fob, these steps will not work. In such cases, you will need to visit a qualified locksmith or your Dodge dealership for professional programming services. They have specialized equipment to program the first key fob for your vehicle.
Here’s how to program your 2013 Dodge Durango key fob yourself:
-
Remote Re-synchronization: Begin by pressing the LOCK button on your existing, working remote five times. Make sure to press the button with approximately two-second intervals between each press. This step helps to re-synchronize the remote and prepare the system for programming.
-
Ignition Activation: Insert the key into the ignition switch of your 2013 Dodge Durango. Turn the ignition key to the RUN position. This is the position just before you would crank the engine to start. Once you turn the key to the RUN position, wait for the ignition chimes to completely stop. This may take a few seconds.
-
Initiate Programming Mode: Take your working remote and press and hold the UNLOCK button. Continue to hold the UNLOCK button down for a duration of 4 to 10 seconds. While still holding the UNLOCK button, press and hold the PANIC button on the same working remote for one second, then release both buttons simultaneously. Listen carefully for a chime. This chime indicates that your 2013 Dodge Durango has successfully entered the remote programming mode. Allow up to 3 seconds for the chime to sound.
-
Program New Remote: Within 30 seconds of hearing the chime, take the new key fob you wish to program. Press and release both the LOCK and UNLOCK buttons on this new remote at the same time. Immediately after releasing both buttons, press and release just the UNLOCK button again on the same new remote. You should hear another chime. This second chime confirms that the new remote has been successfully programmed to your 2013 Dodge Durango. If you have additional key fobs to program, repeat this step now for each new remote. You should hear the door locks cycle after each successful programming of a new remote.
-
Exit Programming Mode and Test: Turn the ignition switch to the OFF position and remove the key from the ignition. Now, test all of your programmed remotes, including the original working remote and any new remotes you just programmed, to ensure they are all functioning correctly with your 2013 Dodge Durango. Test the lock, unlock, and panic buttons on each fob to confirm proper operation.
If you encounter any difficulties while programming your key fob, or if you prefer to have a professional handle the programming, there are resources available to help. You can search for a local key fob programming service in your area. Simply enter your city or zip code online to find professional installers nearby who can assist you with your 2013 Dodge Durango Key Fob Programming needs.
[
