Is your 2020 Ford Edge key fob not working as reliably as it used to? You might be experiencing a common issue: a low battery. Fortunately, replacing the battery in your Ford Edge key fob is a straightforward process you can easily do yourself at home. This guide will walk you through each step to get your key fob working like new again.
Identifying Your 2020 Ford Edge Key Fob Type
Ford Edge models often come with two types of key fobs: the Integrated Keyhead Transmitter (IKT) and the Intelligent Access key (IA key). While both serve the same purpose, their battery replacement process varies slightly. Let’s identify which type you have.
- Integrated Keyhead Transmitter (IKT): This type often has a visible slot near the keyring area.
- Intelligent Access Key (IA key): This key fob usually has a removable backup key. You’ll need to remove this backup key to access the battery compartment.
Regardless of which type you own, the process is designed to be user-friendly and doesn’t require any special tools beyond a small coin or flat blade screwdriver.
Tools You’ll Need
Before you begin, gather these simple tools:
- A new CR2032 battery. This is the standard battery for most Ford key fobs, but always double-check your owner’s manual or the markings on your old battery to confirm.
- A thin coin (like a penny or nickel) or a small flat blade screwdriver.
Replacing the Battery in an Integrated Keyhead Transmitter (IKT)
If you have the IKT style key fob, follow these steps:
-
Open the Battery Cover: Locate the slot near the key ring on your key fob. Insert the thin coin or flat blade screwdriver into this slot. Gently twist the coin or screwdriver to pry open the battery cover.
-
Remove the Rubber Gasket (If Necessary): After opening the cover, check if a rubber gasket comes off with it. If not, carefully peel it away from the transmitter. This gasket helps protect the key fob from moisture.
-
Take Out the Old Battery: Remove the old battery from its housing. Note the orientation of the battery (+ side up or down) before removing it.
-
Insert the New Battery: Place the new CR2032 battery into the housing, ensuring it’s in the correct orientation as the old one. Press down on the battery to make sure it’s securely seated.
-
Reattach the Battery Cover: Snap the battery cover back onto the key fob until it clicks into place, ensuring it’s firmly closed.
Replacing the Battery in an Intelligent Access Key (IA Key)
For the Intelligent Access key, the process is slightly different:
-
Remove the Backup Key: Locate the release button or latch to remove the backup key from your IA key fob.
-
Open the Battery Cover: Once the backup key is removed, you’ll find a slot where the key was located. Insert your thin coin or flat blade screwdriver into this slot and gently twist to open the battery cover.
-
Remove the Old Battery: Take out the old battery, again noting its orientation.
-
Insert the New Battery: Insert the new CR2032 battery in the correct orientation and press it firmly into place.
-
Reattach the Battery Cover and Backup Key: Snap the battery cover back onto the transmitter until it’s secure. Finally, slide the backup key back into its slot until it locks into position.
Battery Disposal
Remember to dispose of the old battery responsibly. Check your local regulations for proper battery disposal methods. Many stores that sell batteries also offer battery recycling programs.
Conclusion
Replacing the battery in your 2020 Ford Edge key fob is a simple maintenance task that can save you time and hassle. By following these steps, you can quickly restore your key fob’s functionality and ensure you can continue to access and start your vehicle without issue. Don’t worry, replacing the battery will not cause your key fob to lose its programming with your car; it should work immediately after the new battery is installed.
