Lost your key fob or need to program a new one for your 2008 Chevrolet Silverado? Don’t worry, you can easily program your key fob yourself without a trip to the dealership. This guide provides clear, easy-to-follow instructions for programming your 2008 Silverado key fob, saving you time and money.
There are two main procedures for programming your key fob, depending on whether your 2008 Silverado is equipped with Driver Information Center (DIC) buttons. Let’s walk through both methods step-by-step.
Programming Your 2008 Silverado Key Fob with Driver Information Center (DIC) Buttons
If your Silverado has buttons on the steering wheel that control the Driver Information Center, use this procedure:
-
Turn the Ignition to the “ON” Position: Insert your key into the ignition and turn it to the “ON” position. This is the position right before you start the engine. You need to be able to access the Driver Information Center through your steering wheel controls.
-
Access “RELEARN REMOTE KEY” in the DIC: Use the vehicle information button (often depicted as a car with an “i” or labeled “INFO”) to scroll through the Driver Information Center menu. Continue pressing the button until you see “PRESS TO RELEARN REMOTE KEY” displayed on the screen.
-
Initiate Remote Key Learning: Once “PRESS TO RELEARN REMOTE KEY” is displayed, press the set/reset button (often labeled “SET” or “RESET”). The display will change to “REMOTE KEY LEARNING ACTIVE,” indicating that the vehicle is now in programming mode.
-
Program the Key Fob: Take your key fob and simultaneously press and hold the LOCK and UNLOCK buttons. Hold both buttons for approximately 15 seconds. You should hear a chime sound, confirming that the key fob has been successfully programmed.
-
Program Additional Key Fobs (Optional): If you have additional key fobs to program, repeat step 4 immediately for each fob. You can program up to eight remotes for your 2008 Chevrolet Silverado.
-
Exit Programming Mode: Turn the ignition key to the “OFF” position and remove the key from the ignition.
-
Test Your Key Fob(s): Test all programmed key fobs to ensure they are working correctly by locking and unlocking your doors, and activating other remote functions if applicable.
Programming Your 2008 Silverado Key Fob Without Driver Information Center (DIC) Buttons
If your 2008 Silverado does not have Driver Information Center buttons on the steering wheel, use this alternative procedure:
-
Prepare the Vehicle: Ensure your vehicle is in Park (P) and the ignition key is in the “ON” position. Turn the key as far as you can without starting the engine.
-
Access “RELEARN REMOTE KEY” using Odometer Reset Stem: Locate the trip odometer reset stem on your instrument panel (it’s usually a small button protruding from the cluster). Press and release this stem repeatedly until “RELEARN REMOTE KEY” is displayed in the instrument cluster.
-
Activate Remote Key Learning: Press and hold the trip odometer reset stem for approximately three seconds. The message “REMOTE KEY LEARNING ACTIVE” will appear, signaling that the system is ready to program a key fob.
-
Program the Key Fob: Take your first key fob and simultaneously press and hold the LOCK and UNLOCK buttons for about 15 seconds. A chime will sound to confirm successful programming of the remote.
-
Program Additional Key Fobs (Optional): If you have more key fobs to program, repeat step 4 for each additional remote immediately. Remember, a maximum of eight remotes can be programmed to your 2008 Silverado.
-
Exit Programming Mode and Test: Turn the ignition key to the “OFF” position and remove the key. Test each programmed key fob to verify proper operation of the lock and unlock functions.
By following these instructions, you can easily program your 2008 Silverado key fob and regain full remote access to your vehicle. If you need a replacement key fob for your Silverado or any other vehicle, visit Keylessentryremotefob.com for a wide selection of quality key fobs.
