How to Change Battery in Jeep Key Fob 2020

Knowing how to change the battery in your 2020 Jeep key fob is a simple skill that can save you time and money. This guide will provide a clear, step-by-step process to replace your Jeep key fob battery quickly and easily.

Replacing Your 2020 Jeep Key Fob Battery: A Step-by-Step Guide

This section will walk you through the process of changing the battery in your 2020 Jeep key fob. Don’t worry, it’s easier than you think! You’ll need a small flathead screwdriver and a CR2032 battery.

1. Locate the release button: On the side of your Jeep key fob, you’ll find a small release button. This button is usually near the key ring.
2. Release the metal key: Press the release button and gently slide the metal key out of the fob.
3. Open the fob: Using the metal key or a small flathead screwdriver, carefully pry open the key fob casing. Start at the notch where the metal key was located. Be gentle to avoid damaging the plastic.
4. Remove the old battery: Once the fob is open, you’ll see the CR2032 battery. Gently pry it out using your flathead screwdriver or fingernail.
5. Insert the new battery: Place the new CR2032 battery into the fob, making sure the positive (+) side is facing up. Press down gently until it clicks into place.
6. Close the fob: Align the two halves of the key fob and press them together until they snap shut.
7. Reinsert the metal key: Slide the metal key back into its slot.

Replacing the battery in a 2020 Jeep key fob

Which Battery Does My 2020 Jeep Key Fob Use?

All 2020 Jeep key fobs utilize the common and readily available CR2032 battery. These batteries are inexpensive and can be found at most drugstores, electronics stores, and online retailers.

What if My Jeep Key Fob Still Doesn’t Work After Changing the Battery?

If your key fob is still malfunctioning after a battery change, there could be other issues at play. It might be a problem with the key fob’s internal circuitry or the vehicle’s receiver.

Programming a Jeep key fob

Key Fob Troubleshooting Tips for 2020 Jeep Models

Sometimes, a dead battery isn’t the only culprit behind a malfunctioning key fob. Here are a few additional troubleshooting tips:

• Check for physical damage: Inspect your key fob for any cracks, broken buttons, or water damage.
• Try reprogramming your key fob: Consult your owner’s manual for instructions on how to reprogram your key fob. This process may involve a specific sequence of button presses or require a visit to a dealership.
• Consider a replacement key fob: If all else fails, you may need to purchase a new key fob.

How Long Do Jeep Key Fob Batteries Last?

Jeep key fob batteries typically last between 3 to 5 years, depending on usage.

Different types of Jeep key fobs

Conclusion: Keeping Your 2020 Jeep Key Fob in Top Shape

Changing the battery in your 2020 Jeep key fob is a straightforward task that requires minimal tools and expertise. By following the simple steps outlined above, you can easily keep your key fob functioning properly and avoid the inconvenience of a dead battery. Remember to always use a CR2032 battery for optimal performance.

FAQ

1. How do I know if my Jeep key fob battery is dead? The most obvious sign is that your key fob will stop working or have reduced range.
2. Can I change the battery in my Jeep key fob myself? Yes, absolutely! It’s a simple DIY task.
3. What type of battery does my 2020 Jeep key fob use? A CR2032 battery.
4. Where can I buy a CR2032 battery? Most drugstores, electronics stores, and online retailers carry them.
5. What if my key fob still doesn’t work after changing the battery? You may need to reprogram your key fob or have it checked for other issues.
6. How often should I change my Jeep key fob battery? Every 3-5 years, or sooner if you notice reduced performance.
7. Can I damage my key fob by changing the battery myself? As long as you are careful and gentle, you should be able to change the battery without causing damage.

Need help? Contact us via WhatsApp: +1(641)206-8880, Email: [email protected] or visit us at 123 Maple Street, New York, USA 10001. We have a 24/7 customer support team. We also have articles on Key Fob programming and other car diagnostic topics available on our website.