Lost your Pontiac G6 key fob or need to program a replacement? Instead of heading straight to a dealership or locksmith and facing hefty fees, you can actually program a new key fob yourself right at home. This simple DIY process can save you both time and money. This guide will walk you through the steps to program your Pontiac G6 key fob, allowing you to regain keyless entry and get back on the road without the extra expense.
Step-by-Step Programming Instructions for Your Pontiac G6 Key Fob
Programming your Pontiac G6 key fob is surprisingly straightforward and requires no special tools. Just follow these steps carefully, and you’ll have your key fob programmed in minutes:
- Get in Position: Sit comfortably in the driver’s seat of your Pontiac G6. Some find it easier to perform these steps from the front passenger seat, so choose whichever is most convenient for you.
- Key Out of Ignition: Remove the ignition key completely from the ignition lock cylinder.
- Close All Doors: Ensure that all doors of your Pontiac G6, including the trunk and hood, are fully closed.
- Fuse Removal: Locate the fuse panel in your Pontiac G6. Refer to your owner’s manual if you are unsure of its location. Find and remove the “MALL PGM” fuse from this panel. This fuse is related to the মাল্টিপ্লেক্সড অ্যাক্সেস কন্ট্রোল লজিক (Multiplexed Access Control Logic) system.
- Accessory Mode: Turn the ignition key to the “ACC” (Accessory) position. This turns on some of your car’s electronics but does not start the engine.
- Ignition Cycle: Turn the ignition key OFF, and then quickly back to the “ACC” position again within one second. This quick cycling is important for initiating the programming sequence.
- Open and Close Door: Open and then close the driver’s side door of your Pontiac G6. Make sure it’s a complete open and close motion.
- Listen for the Chime: Pay close attention and listen for a chime sound. This chime is your signal that the remote control door lock receiver has successfully entered the programming/diagnostic mode. If you do not hear a chime after a few seconds, you will need to start the process again from step 1.
- Transmitter Synchronization: Take your key fob transmitter and press and hold down both the “LOCK” and “UNLOCK” buttons simultaneously for a full 14 seconds. During this 14-second hold, you may hear a chime at around 7 seconds, indicating successful synchronization, and another chime at approximately 14 seconds, confirming successful programming of the key fob.
- Program Additional Transmitters: If you have more than one key fob transmitter to program (up to a maximum of 4), repeat step 9 immediately for each additional transmitter you want to program.
- Key Removal: Once you have programmed all desired key fobs, remove the ignition key from the ignition lock cylinder.
- Fuse Reinstallation: Go back to the fuse panel and reinstall the “MALL PGM” fuse that you removed in step 4. Ensure it is securely placed back in its original position.
- Functionality Test: Thoroughly test all of your programmed key fobs to ensure they are working correctly. Press the “LOCK” and “UNLOCK” buttons on each fob to verify that they control the door locks as expected.
By following these detailed instructions, you can easily program your Pontiac G6 key fob and avoid unnecessary expenses. This DIY method puts you back in control of your vehicle’s keyless entry system quickly and efficiently. Keep these instructions in a safe place for any future key fob programming needs.