Lost your 2006 Acura Tl Key Fob or need to program a replacement? The good news is you can often handle the programming process yourself, right in your driveway. This guide provides a clear, step-by-step method to program your 2006 Acura TL key fob, saving you time and potentially money.
Before starting, ensure all doors, the hood, and the trunk of your 2006 Acura TL are completely closed. This is a critical prerequisite for the programming sequence to function correctly. Acura’s system is designed to prevent accidental programming, and ensuring all closures are secure is part of this safeguard.
Here’s exactly how to program your 2006 Acura TL key fob:
-
Ignition ON (Position II): Insert the key into your Acura TL’s ignition switch. Turn the key to the “ON” position, also known as Position II. This is the position where your dashboard lights illuminate, but you do not start the engine.
-
Press Key Fob Button (Within 1-4 Seconds): Immediately after turning the ignition to ON, and within a tight 1 to 4 second window, press either the “Lock” or “Unlock” button on your 2006 Acura TL key fob. Aim the fob towards the keyless receiver. This receiver is typically located behind the driver’s side dashboard area.
-
Ignition OFF (Within 1-4 Seconds): Again, maintaining the 1 to 4 second timing, turn the ignition switch back to the “OFF” position. Do this promptly after pressing the key fob button.
4-10. Repeat ON/OFF and Button Press (Three More Times): Repeat the sequence of steps 1-3 for three additional times. This means you will cycle the ignition ON, press the key fob button, and then OFF, a total of four times in quick succession. Accurate timing is important for the system to recognize the programming initiation.
-
Ignition ON (Position II) – Fifth Cycle: For the fifth time, turn the ignition switch to the “ON” position (Position II). Leave it in the ON position for this step.
-
Press Key Fob Button – Listen for Door Locks: Within 1 to 4 seconds of turning the ignition ON for the fifth time, press the “Lock” or “Unlock” button on your 2006 Acura TL key fob one more time. Listen carefully for the distinct sound of the door lock actuators. You should hear them cycle – locking and then unlocking. This confirms that your Acura TL has successfully entered the key fob programming mode. To finalize the entry into programming mode, press the button a second time after hearing the locks cycle.
-
Program Additional Fobs (Within 10 Seconds): If you have additional 2006 Acura TL key fobs you wish to program, you have a 10-second window after the door lock confirmation. Aim each additional key fob at the receiver and press either the “Lock” or “Unlock” button. Each successful programming of a key fob will be confirmed by the sound of the door lock actuators cycling again. You can program up to three key fobs in total, including the original one.
-
Ignition OFF and Key Removal: Turn the ignition switch to the “OFF” position and remove the key from the ignition. This action will exit the programming mode.
-
Test All Key Fobs: Thoroughly test all programmed 2006 Acura TL key fobs to ensure they are working correctly. Check the lock and unlock functions, and any other functions your key fob may have, such as remote trunk release or panic button.
By meticulously following these steps, you should have successfully programmed your 2006 Acura TL key fob. If you encounter difficulties, double-check each step, paying close attention to the timing requirements. Ensure you are using a compatible key fob designed for the 2006 Acura TL model. If issues persist, consulting your Acura owner’s manual or a professional automotive locksmith may be necessary.
